Load 10 x 15 cm (4 x 6 inch) photo paper
You can load 10 x 15 cm (4 x 6 inch) photo paper into the input tray of your HP All-in-
One. For the best results, use 10 x 15 cm (4 x 6 inch) HP Premium Plus Photo Paper
or HP Premium Photo Paper with tab. For more information, see
Recommended
papers for printing and copying
.
Note
For borderless printing, the HP All-in-One only supports printing 10 x 15
cm (4 x 6 inch) paper with tab.
Tip
To help prevent rips, wrinkles, and curled or bent edges, store all paper
flat in a resealable bag. If the paper is not stored properly, extreme changes in
temperature and humidity might result in curled paper that does not work well
in the HP All-in-One.
To load 10 x 15 cm (4 x 6 inch) photo paper with tab in the input tray
1.
Remove the output tray.
2.
Remove all paper from the input tray.
3.
Insert the stack of photo paper into the far-right side of the input tray with the
short edge forward and the print side down. Slide the stack of photo paper
forward until it stops.
Load the photo paper so that the tabs are closest to you.
4.
Slide the paper-width guide inward against the stack of photo paper until it stops.
Do not overload the input tray; make sure the stack of photo paper fits within the
input tray and is no higher than the top of the paper-width guide.
5.
Replace the output tray.
For best results, set the paper type and paper size before copying or printing. For
information on changing paper settings, see the onscreen
HP Image Zone Help
.